Built for even, controlled wall washing
Most LED strip lighting spreads light in a wide arc, which is great for cove lighting but terrible when you want a clean, uniform sweep up a wall. This wall washer strip uses 2835 SMD chips with a 10-degree lighting angle so the beam travels instead of scattering. Mount it at the base of a wall, in a recessed floor detail, or at the top of a niche, and you get that controlled gradient designers love. The strip body measures 0.78" (20mm) wide and 0.39" (10mm) high — a bit chunkier than a standard tape because of the optic — so plan your channel or reveal accordingly.
Light quality you can trust
With a CRI of 90+, colours stay honest. Beige paint stays beige, walnut stays warm, and stone texture reads as texture rather than grey mush. Pick 3000K for a cozy residential feel in living rooms, bedrooms and hospitality spaces, or 4000K for a crisper, more neutral look in offices, retail and modern interiors. Typical output is 450 lumens per foot, which will vary slightly depending on the Kelvin temperature chosen, and there are 14 LED chips per foot for a tight, dot-free wash when used with a diffuser.
Technical specifications
SKU: WWSTRIP-3000
Brand: LED MONTREAL
Voltage: 24V DC
Chip: 2835 SMD
Lighting angle: 10 degrees
Length: 6 feet (1.83 meters)
Width: 0.78" (20mm)
Height: 0.39" (10mm)
Cut points: every 7 LEDs (6 inches)
LED chips: 14 per foot
Power consumption: 5.8W / foot
Recommended transformer: 7.25W / foot, Class 2
Luminous flux: 450 lumens / foot
Colour temperatures: 3000K / 4000K
CRI: 90+
Protection: IP67
Adhesive: 3M tape
Operating temperature: 40C to -20C
Lifetime: 10 000+ hours
Certification: cULus
Dimmable: Yes
Electrical, installation and compatibility
This is a strip only product, so you supply the rest of the system. Size your driver from the 7.25W per foot recommendation and make sure it is a Class 2 transformer — a 6-foot run needs a power supply sized accordingly, and running several sections means adding up the footage first. Dimming works two ways: a DC low voltage remote or wall panel placed after the driver, or an AC dimmable power supply controlled by a compatible wall dimmer. Clean the surface, peel the 3M self-adhesive backing and press firmly; for permanent installs, an aluminum extrusion is strongly recommended because heat dissipation is necessary for this strip to reach its rated life. Cut only on the marked points, every 7 LEDs (6 inches), and reseal or re-solder cut ends properly given the IP67 construction.
Where to use it and what's included in the documentation
Think feature walls in condos and basements, stairwell accents, hotel and office corridors, restaurant banquettes, retail backdrops, gallery and showroom walls, and exterior soffit details in sheltered spots — this strip is made for indoor or light outdoor use only, and its 40C to -20C operating range and IP67 rating suit Canadian conditions when it isn't left fully exposed. It's approved for both residential and commercial projects. The full technical spec sheet for the 24V Wall Washer Strip 6 feet - 10 Degree Angle is available in the Documentation tab of this page, with every dimension, electrical value and rating listed above — handy when you're submitting for approval or sizing a run on site.
