Built for long, clean runs
This is a bulk roll of LED strip lighting — 25 meters of flexible tape with no connectors attached, so nothing forces you into pre-set lengths. The flexible circuit board is a 2-ounce copper build, which helps the strip carry current and shed heat over long runs, and it is topped with Epistar 3014 SMD chips at a density of 120 LEDs per meter. At 10mm wide and just 2mm high, it tucks into shallow coves, cabinet rails, shelf lips and reveals where nothing else fits. A 3M self-adhesive backing holds it in place while you work, and the tape can be cut every 6 LEDs (50mm) for tight, exact segments.
Light quality you will actually notice
Typical output is 1000 lumens per meter in 3000K warm white, the temperature most homeowners ask for in kitchens, living rooms and bedrooms because it flatters wood, stone and warm paint. A CRI of 80+ keeps colours honest on countertops, merchandise and artwork, and the 120° lighting angle spreads light wide instead of firing a narrow stripe, so the individual diodes blur into a continuous line — especially behind a frosted diffuser. With 120 LEDs per meter, the dots sit close together, which is exactly what you want for cove lighting and any run seen at close range.
Technical specifications
SKU: 25M3014-3000
Brand: LED MONTREAL
Chip: Epistar 3014 SMD
Chip density: 120 LEDs per meter
Circuit board: 2 ounces
Length: 25 meters
Width: 10mm
Height: 2mm
Voltage: 24V DC
Power consumption: 12W/m
Recommended power supply: 14.4W/m
Typical luminous flux: 1000 Lumens/m
Colour temperature: 3000K Warm White
CRI: 80+
Lighting angle: 120°
Can be cut: all 6 LEDs (50mm)
iP rating: iP20, indoor use only
Operating temperature: 40C to -10C
Lifespan: 50 000+ hours
Certification: cULus for Canada and USA E498952
Connections: not included
Wiring, dimming and installation
The strip runs on 24V DC, so it needs a low voltage power supply. Size it at 14.4W/m of strip, then respect the run limit: with transformer power capped at 96W, the maximum recommended length is 6.6 meters per section (96W divided by 14.4W/m). Longer areas are simply split into several sections fed from the driver — this is the safe, code-friendly way to wire a big installation and it also prevents voltage drop at the far end. The tape is dimmable, either with a low voltage dimmer/remote combo or with a dimmable power supply controlled by a 120V AC dimmer. Since connections are not included, plan your solderless connectors or solder joints, and always mount the strip on a heat-dissipating surface or inside an appropriate aluminum channel — heat is the number one enemy of LED tape lifespan.
Where it works and what is on the page
Think kitchen under-cabinet task light, island toe-kicks, pantry and closet shelving, stair nosings, cove lighting around a ceiling perimeter, bathroom mirror surrounds outside the wet zone, bar fronts, retail display cases, jewellery and bakery counters, office reception walls and hotel corridors. Its iP20 rating means dry indoor locations only, so keep it out of exposed exterior and wet areas. The technical spec sheet for this roll is available in the Documentation tab of this page — download it for the full chart before you order your drivers, channels and connectors for SKU 25M3014-3000.
