Built as a system, not a one-off fixtureThe ASTELLA track by TUROLIGHT is an
H-type single-circuit track system, one of the most common track profiles used in North American homes and businesses. The rail carries three conductors —
P + N + PE (line, neutral and ground) — inside a single extruded channel, with a polarity line marked on the body so lampholders, connectors and feeds are always oriented correctly. The underside of the profile is open and elongated to receive heads, while the plain back sits flat against the ceiling or the wall. Because it is a one-circuit track, every head on the run is powered and switched together: simple, predictable, and easy for an electrician to commission.
Electrical and safety detailsThis track operates at
120V, 60Hz with a
20A rating, and is classified
Class I, IP20, meaning it is intended for dry indoor locations and relies on a proper ground connection. To reduce the risk of fire and electric shock, only fixture assemblies marked for use with TUROLIGHT track should be installed on it. The power must be shut off at the main panel or fuse box before installing the rail or any accessory, and all local installation requirements must be respected. After all sections and connectors are in place, every open end of the run must receive a dead-end fitting, with the set screws tightened before power is restored.
Installation, step by stepPosition the rail over the outlet box and mark the mounting holes on the ceiling or wall. On drywall or plaster, drill 5/8 holes and fix the rail with the
toggle bolts supplied; on wood surfaces, use standard #10 wood screws (not supplied). Strip the box wires to
3/8" and secure them to the screw terminals of the live-end connector — no need to wrap the wire around the screw. Before sliding any connector into the open end of the track, loosen its set screws and select the correct ground tab: the ground tabs must be prepared before sliding onto the NON-GROUND conductor-side tab of the section you are joining, and if the wrong tab has been removed, that connector must not be used because grounding would not be maintained. To fit a lampholder, align the polarity lines of the track and of the head, push the top of the
mounting adapter (with its contact tabs) into the track slot and turn 90°; if it does not turn easily, do not force it — turn the other way. To remove a head, press the release lever with your index finger and turn 90°. Then switch the main power back on.
Technical specificationsSKU: AST-TRK-H-06-BK
Brand: TUROLIGHT
System: ASTELLA Track System, H-type
Circuit: Single circuit, 1 way (P + N + PE)
Length: 6 ft
Voltage: 120V, 60Hz
Current rating: 20A
Protection: Class I, IP20
Finish: Black
Mounting: Ceiling or wall, toggle bolts supplied
Where it works and what goes with itA 6-foot run is a sweet spot for a
kitchen island, a hallway, a dining area, a home office or a feature wall, and it scales up beautifully in
retail and commercial spaces: boutiques, galleries, cafés, showrooms, salons and reception areas where merchandise and artwork keep moving. Combine sections to reach the length you want — the
2 ft black track,
4 ft black track and
8 ft black track are part of the same H-type single-circuit family, and the
12 ft version is available when a long uninterrupted run is the goal. The ASTELLA range also includes live-end and dead-end feeds and joiners identified in the installation sheet (AST-TRK-H-LEC, AST-TRK-H-EC, AST-TRK-H-XC, AST-TRK-H-LC, AST-TRK-H-TC, AST-TRK-H-SC, AST-TRK-H-FC, AST-TRK-H-MJ). The full
spec sheet and installation instructions for AST-TRK-H-06-BK are available in the Documentation tab — worth a read before you drill your first hole.