A complete kit, not just a roll of tape
Most people buy a strip and then hunt for the parts that make it work. This one arrives as a system: a 5 meter single colour LED strip at 120 LED/m, one multi zone RF remote, one multi zone controller and one power supply. That means the electrical side is already matched — strip, controller and supply all speak 24V — and you can focus on layout instead of guessing at components. Multiple strips are shown in our product photos to illustrate the point: one remote can operate several separate runs, each assigned to its own zone, so the kitchen, the island and the hallway can be switched independently without extra wall switches. If your project is bigger than the basic kit, use the drop-down menus above to build the version you need.
Light quality and construction
The flexible circuit is populated with 3528 SMD diodes at a density of 120 LED/m, delivering 850 lumens per meter through a wide 120 degree lighting angle. High density plus a wide angle is the combination that gives you a continuous ribbon of light rather than a row of dots, which is exactly what you want in a cove, under a cabinet or inside a millwork reveal. At only 8 mm wide and 5 mm thick, the tape disappears into narrow channels, toe-kicks, stair nosings and shelf edges. Pick your white before you order: Warm White 3000K reads soft and golden, Natural White 4500K is a clean neutral for task areas, and Cool White 6000K gives a bright, modern feel for display and commercial spaces.
Technical specifications
SKU: MZ352824V
Brand: LED MONTREAL
Dimensions: 5 meter long, 8 mm wide, 5 mm thick
Required power: 24V, 9.6 W/m
Recommended power: 24V, 12 W/m
LED type: 3528 SMD
LED density: 120 LED/m
Lighting angle: 120 degrees
Luminous intensity: 850 lm/m
Available colours: Warm White (3000K), Natural White (4500K), Cool White (6000K)
Kit contents: 5 m strip, 1 multi zone remote, 1 multi zone controller, 1 power supply
Electrical and installation notes
Because this is a 24V low voltage led strip, voltage drop over a long run is less of a worry than with 12V tape, and the whole installation stays gentle on the hands during service. Size your supply generously: the strip requires 9.6 W/m, and the recommended power is 12 W/m, which leaves healthy headroom instead of running a supply at its limit. Feed power from both ends or at a mid-point on very long runs, keep the tape on a straight, clean surface, and mount it in an aluminum profile whenever the strip is visible or close to wood — the channel hides the diodes behind a diffuser and helps the tape breathe. The multi zone controller sits between the power supply and the strips; the RF remote talks to it through walls and cabinet doors, so you can hide the electronics inside a cabinet, above a ceiling or in a mechanical room and still control the light from your couch.
Where it works, and what you get
Think kitchen under-cabinet task light, a glowing ceiling cove in a condo living room, step lights on a basement staircase, backlit bathroom mirrors and vanities, bar and back-bar accents, retail shelving, reception desks, salon stations and office feature walls. In a home renovation, one kit can cover the main floor with three or four zones; in a small business, it turns a plain wall or display into a feature without rewiring. For full values before you spec the job, the technical spec sheet for this indoor LED strip kit is available in the Documentation tab of this page.
