What it is
The Single Color Presoldered 2 Strand Flat Wire for LED Strips is a two-conductor low-voltage lead made for single colour LED strip lighting. Two strands carry the positive and the negative, which is exactly what a monochrome strip needs — one colour temperature or one colour, no data line, no extra channels. The ends arrive presoldered, so the copper is already tinned and protected, ready to meet the copper pads of your led strip lights or to slide into a solderless connector.
Technical specifications
Brand: LED MONTREAL
SKU: FW1M
Type: presoldered 2 strand flat wire for LED strips, single colour
Wire gauge: 20 AWG
Lengths: 30 cm, 1 metre, 2 metres
Colour: white or black
Use: residential and commercial projects
Why the gauge and the shape matter
Low-voltage LED runs lose a little voltage over distance, and the thinner the wire, the faster that happens — the end of the run goes dimmer or slightly warmer looking than the beginning. A 20 gauge conductor gives you more copper than the hair-thin leads that often ship in the box, so a bridge across a hood or a jump from one cabinet to the next stays bright and even. The flat profile is the other half of the story: it sits flush. Inside an aluminum LED channel, under a diffuser, behind a toe-kick or stapled along the back of a valance, flat wire disappears where round wire creates a bump you can see through the lens.
Installation and compatibility
Plan the layout first: measure the gap you need to cross, then pick 30 cm for a cabinet-to-cabinet jump, 1 metre for a range hood or a window, 2 metres for a longer detour back to the power supply. Respect polarity — mark the positive strand before you tuck the wire away, because a reversed lead simply will not light. Cut the strip only on its marked cut lines, match the presoldered tips to the copper pads, and secure the wire so it is never pulled at the joint. White wire against white melamine or ceiling, black wire against dark cabinetry or a black channel: choose the colour that hides. This lead is intended for single colour 2-pin LED strips; multi-channel strips such as RGB or tunable white need a wire with more conductors.
Where it earns its keep
Under-cabinet kitchen lighting that has to bypass a stove fan or a built-in microwave, cove lighting interrupted by a structural beam, stair nosing lit step by step, closet and pantry shelving, bathroom mirror surrounds, display cases and retail shelving, bar fronts, reception desks and basement renovations. Contractors keep several lengths on the truck because job sites never measure the way the drawing did. Documentation: no spec sheet is provided for this accessory — the wire gauge, lengths and colours listed above are the full set of published details, and any question about your specific strip layout is best answered with the strip's own documentation in hand.
