What this part is
The CANOLIGHT end cap is a small termination component that closes the open extremity of a 180° COB high voltage LED strip installation. Rather than leaving a cut end exposed at the end of a run, the cap slips onto the profile and shuts it off cleanly. It is not a light source and it does not change the output of the strip — it protects and finishes it. Think of it the same way you think of a trim ring on a recessed light or an escutcheon on a plumbing rough-in: nobody notices it when it is there, everybody notices it when it is missing.
Fit and compatibility
This end cap is dedicated to the CANOLIGHT 180° COB high voltage LED strip, model CL-ST-180-11065. It is shaped to match that specific channel profile so the fit is snug and gap-free, with no light leaking around the edges and no visible step between the strip and the cap. Because it is model-specific, do not assume it will suit other strip widths, other beam formats or other brands of LED tape light — pair it only with the strip it was designed for. On a typical run you will use one cap per open end; on segmented layouts, corners or returns, count every termination point in your take-off so nothing is left open on site.
Why terminations matter on high voltage COB strip
A high voltage COB LED strip is a continuous, dot-free emitter, which is exactly why installers choose it for coves, reveals and signage. That continuity also means the end of the run is highly visible: an open end shows the internal structure and breaks the illusion of a single line of light. Sealing the end with the matching cap keeps the line clean, keeps dust and debris from working their way in, and helps the assembly hold its shape over years of service. With strips operating at higher voltage levels, a secure and correctly fitted accessory is also a matter of doing the job properly — never leave a cut extremity unfinished and unprotected.
Installation tips
Work from a clean, square cut on the strip, wipe the profile free of dust, then seat the cap fully so it sits flush against the end of the run. Do it before the strip is pushed into a cove, a reveal or a cabinet, when you still have room to work with both hands. On long architectural runs, dry-fit the caps first to confirm alignment with the mounting surface, then secure the strip. Keeping one or two spare caps in the van is worth it: site changes and last-minute cuts happen on almost every project.
Applications and documentation
You will use this end cap wherever the 180° COB strip is specified — architectural coves, backlit signage, display cases and retail shelving, linear feature walls, hospitality interiors, reception desks, millwork and high-end residential lighting across Canada. It is the kind of detail that separates professional-grade work from a basic install, and it costs you nothing but a minute of your time on site. The technical PDF spec sheet (CL-ST-180-11065-End cap Spec Sheet) is available in the Documentation tab of this page — order under SKU CL-ST-180-11065-End cap and finish your COB strip light run the right way.
