Nov 06, 2026 / By the Lumibox team / in LED Guides
An under-cabinet range hood is the right choice when an upper cabinet already sits above your range: it mounts beneath that cabinet, captures smoke where it rises and connects to the duct that runs up through the cabinet. If the wall above the range is open, a wall mount chimney hood takes over. For a hood that disappears, a built-in insert hides inside a cabinet or a decorative hood enclosure. After that, three criteria narrow the choice: width, airflow in CFM and noise in sones.
This guide is for homeowners renovating a kitchen, landlords replacing a tired old fan, and cabinetmakers or contractors building custom kitchens across Canada. Every model figure quoted here comes from the spec pages of the LUMIFARO hoods in our range hoods category.
The type of hood depends first on what is above the range: an upper cabinet, an open wall or a custom enclosure.
An under-cabinet hood screws to the underside of the upper cabinet, right above the cooking surface. It is the classic Canadian kitchen hood and often the simplest to replace: remove the old one, connect the duct and the wiring, fasten the new one. In our under-cabinet range hoods, the Baby-Pro I 24231 30-inch hood moves 390 CFM with a 3-speed control, two GU10 LED bulbs and 5-layer aluminum grease filters. The Baby-Pro II 24232, also 30 inches and 390 CFM, adds a 3-speed electronic control panel with a built-in LCD clock, two 5W LED bulbs and stainless steel filters.
A wall mount hood fastens directly to the wall, and its chimney rises to the ceiling to hide the duct. It becomes a design feature of the kitchen: a stainless steel chimney matches stainless appliances, while a black hood gives a more contemporary look. LUMIFARO wall mount range hoods come in the Rainbow, Rainbow-Pro and Slim series, in black or stainless steel, from 280 to 860 CFM. For example, the Rainbow-Pro 24430-600-S in stainless steel delivers 600 CFM and carries cUL/CSA approval.
An insert, also called a range hood insert or custom hood liner, installs inside a cabinet or a decorative enclosure built by the cabinetmaker. Only the filters and the control remain visible. The Elite series includes a 22-inch model (24122) and a 28-inch model (24128), both at 490 CFM. The Elite-Pro series steps up to 600 CFM with the 30-inch 24030 and to 860 CFM with the 36-inch 24036, both with stainless steel baffle filters.
An island hood hangs from the ceiling above a cooktop set in the island, with a duct running through the ceiling. Check the spec page to make sure the mounting type planned by the manufacturer matches your kitchen.
| Model | Type | Width | Airflow | Noise (low to high) | Filters | Lighting |
|---|---|---|---|---|---|---|
| Elite 24122 | Built-in | 22 in | 490 CFM | 0.6 to 8.0 sones | 5-layer aluminum | 2 x 5W LED bulbs |
| Elite 24128 | Built-in | 28 in | 490 CFM | 0.6 to 8.0 sones | 5-layer aluminum | 2 x 5W LED bulbs |
| Elite-Pro 24030 | Built-in | 30 in | 600 CFM | 0.7 to 9.0 sones | Stainless baffle | 2 x 5W LED bulbs |
| Elite-Pro 24036 | Built-in | 36 in | 860 CFM | 0.7 to 9.0 sones | Stainless baffle | 2 x 5W LED bulbs |
| Baby-Pro I 24231 | Under-cabinet | 30 in | 390 CFM | 0.7 to 9.0 sones | 5-layer aluminum | 2 x GU10 LED bulbs |
| Baby-Pro II 24232 | Under-cabinet | 30 in | 390 CFM | 0.7 to 9.0 sones | Stainless steel | 2 x 5W LED bulbs |
The most common rule of thumb is simple: the hood should be at least as wide as the cooking surface, and a little wider is even better. Smoke and steam spread as they rise; a hood that is too narrow lets escape what comes off the front and side burners. Measure the range or cooktop, then the space between the cabinets.
A standard range is usually paired with a 30-inch hood, such as the Baby-Pro models or the Elite-Pro 24030. For a wide or professional-style range, look for a 36 range hood like the Elite-Pro 24036. The 22-inch and 28-inch inserts are mostly used when the insert sits inside a decorative enclosure whose inside width is set by the cabinetry. Mounting height above the cooking surface is given in the manufacturer's installation guide: do not guess it.
CFM (cubic feet per minute) is the volume of air the blower can move. The hotter you cook, the more airflow you need. Here are reference points drawn from the models on offer:
More CFM is not always better. A very powerful hood in a tightly sealed house can create negative pressure: the air has to come in somewhere. Depending on the airflow and the type of house, local rules may require makeup air. Have a ventilation contractor, a master electrician or your municipality check this before choosing a high-capacity model.
A hood performs best when it exhausts air outdoors. Common guidelines: a rigid duct, as short and straight as possible, with as few elbows as possible, a backdraft damper and a wall or roof cap. Never vent a hood into the attic or a closed ceiling. The duct diameter should match the hood outlet: the Elite 24128, for instance, exhausts through a 6-inch round vertical vent. Reducing the diameter chokes the airflow and adds noise.
When no outside vent is possible, as in some condos, a recirculating (ductless) hood filters the air and returns it to the kitchen. It needs charcoal filters in addition to grease filters, and it holds back odours without removing moisture. Check the spec page to confirm the model supports this mode before counting on it.
The grease filter protects the blower and the duct. Three families appear in the models on offer:
As a general rule, a metal filter should be washed regularly in hot soapy water, more often if you fry a lot. A clogged filter cuts airflow and strains the motor. To replace a filter or find a part, browse the range hood filters and accessories and match the part with your model.
Hood noise is measured in sones: the lower the number, the quieter the hood. Spec pages give two values, at low and high speed. The Elite 24122 and 24128 run from 0.6 sones on low to 8.0 sones on high. The Elite-Pro and Baby-Pro models run from 0.7 to 9.0 sones. Low speed is for simmering while you chat; high speed is for clearing a smoking pan for a few minutes.
A tip for a calmer kitchen: choose a hood with a little more power than you need and run it at a lower speed. A duct of the right diameter, run as straight as possible, also reduces air whistle.
Almost every hood lights the cooking surface. In the models above, that means two 5W LED bulbs, or two GU10 LED bulbs on the Baby-Pro I 24231. The GU10 base is common and easy to replace; the LED bulb base guide explains how to recognize it. For light that shows food colours accurately, see our guide to colour temperature and CRI.
Hood lighting only covers the range. For the rest of the room, look at LED kitchen lighting ideas and LED under-cabinet light bars for the countertops.
In Canada, an appliance connected to the electrical system must carry a recognized certification. Several LUMIFARO spec pages state cUL/CSA approval, including the Rainbow 24530-480 and the Slim 24900-480. Wiring a new hood, especially when it needs a new circuit or a relocated electrical box, is a job for a master electrician, who can also tell you whether a duct through an exterior wall requires a permit in your municipality.
LUMIFARO under-cabinet models are grouped in a dedicated category, with full spec pages: width, CFM, sones, filters and lighting. Measure your range and the space between the cabinets before comparing.
LUMIFARO offers under-cabinet (Baby-Pro), wall mount chimney (Rainbow, Rainbow-Pro, Slim) and built-in (Elite, Elite-Pro) range hoods, from 280 to 860 CFM, in black or stainless steel. Each spec page lists width, airflow and noise.
The filter must first match your model. 5-layer aluminum is light and easy to wash; stainless baffle filters hold up better in a greasy kitchen. A recirculating hood also needs a charcoal filter.
An 860 CFM model, such as the Elite-Pro 24036 or the 24436-860, suits large ranges, powerful gas cooktops and open-concept kitchens. Check the makeup air question with a professional.
Choose a hood at least 36 inches wide. The Elite-Pro 24036, a 36-inch stainless steel insert at 860 CFM, is designed for wide ranges and gas cooktops.
A slim hood such as the Slim series keeps a low profile while offering 390 to 600 CFM. A ductless hood traps grease and some odours with charcoal, but it removes neither heat nor moisture; whenever an outside vent is possible, venting remains the better choice.
Ready to choose? Compare under-cabinet range hoods, wall mount range hoods and the full selection of range hoods: each spec page lists width, airflow, noise and filter type to help you find the hood that fits your kitchen.
RANGE HOOD - 280 CFM - STAINLESS STEEL - 24230-S
RANGE HOOD - 24900-480-S - 480 CFM
RANGE HOOD - 480 CFM - RAINBOW - STAINLESS STEEL - 24530-480-S
24436-860 - 24436-860 - STAINLESS
RANGE HOOD - 24030 - BUILT-IN ELITE-PRO 30" - STAINLESS STEEL
RANGE HOOD - 24122 - BUILT-IN ELITE 22" - 490 CFM - STAINLESS STEEL
RANGE HOOD - 24128 - BUILT-IN ELITE 28" - 490 CFM - STAINLESS STEEL
RANGE HOOD - 480 CFM - SLIM - BLACK - 24900-480-BK