Built for a clean, dot-free line of light
The LumenstarLED LS-FLI-2B-24-120-4K uses 2835 SMD LEDs at a density of 120 LEDs per metre on a flexible printed circuit board that bends around corners, follows curves and tucks into tight reveals. That high density is the whole point: the closer the diodes sit, the sooner their beams overlap, and the less you see individual hot spots through a diffuser. At W10 x H1.5mm (W3/8 x H1/16"), the LED tape is thin enough to disappear inside aluminum channels, under cabinet valances and behind crown moulding, and the factory-applied double-sided 3M tape on the back means no clips, no screws, no fuss on most clean, dry surfaces.
Light quality you can trust
With an output of 1575 lumens per metre (475 per foot) and a CRI greater than 90, this LED strip light renders colour honestly — important anywhere people judge what they see: a chef checking a sear, a client checking a paint chip, a shopper checking a sweater. The 4000K neutral white sits between cozy warm white and cool daylight, which is why it is so popular in kitchens, bathrooms, work zones, offices and retail displays. The 120° beam angle spreads light evenly across the surface below instead of punching a narrow stripe, and the tape is dimmable for full control of intensity from bright task light to a soft evening glow.
Technical specifications
Product code: LS-FLI-2B-24-120-4K
Brand: LumenstarLED
Voltage: 24V DC
Wattage: 14.4W/M (4.4W/FT)
Light output: 1575/M (475/FT) lumens
Colour temperature: 4000K
CRI: >90
LED type: 2835, 120 LEDs/M
Beam angle: 120°
Dimmable: Yes
Cut increment: 2" (50mm)
Length: 5M (16.4')
Dimensions (WxH): W10 x H1.5mm (W3/8 x H1/16")
IP rating: 22
Operating temperature: -25~+60°C (-13~140°F)
Wire lead: 12" (30cm) on both ends
Mounting: double-sided 3M tape on the back
Certifications: c UL us Listed
Warranty: 5-year
Wiring, dimming and installation
This is a low-voltage product: it must be powered by a 24V DC LED driver sized for the total load of your run — multiply 14.4W/M by the number of metres you are installing and leave yourself headroom. The 12" (30cm) wire lead on both ends makes feeding from either side easy, which is handy when the driver has to live in a cabinet, a soffit or a nearby closet. Cut only on the marked points every 2" (50mm), and for dimming use a 24V dimming method compatible with your driver and control system. With an IP rating of 22, this tape is meant for dry indoor locations — for showers, exteriors or anywhere it could be splashed, choose a sealed wet-rated tape instead. Clean the mounting surface with alcohol before pressing the tape down, and mount long runs in an aluminum extrusion to keep the LEDs cool and the light diffused.
Where it works and what to download
Real-world uses are everywhere: upper and lower cabinet lighting in a kitchen reno, a continuous cove around a living room ceiling, backlighting a bathroom mirror or floating vanity, lighting glass display shelves in a boutique or jewellery counter, accenting a bar front in a restaurant, marking stair stringers in a finished basement, or adding clean task light over a workbench or reception desk. The c UL us Listed mark and 5-year warranty give Canadian electricians and homeowners confidence in both new construction and renovations. The full technical PDF (INDOOR 2835 FLEXIBLE LED TAPE) is available in the Documentation tab — download it for the complete specs before you size your driver and plan your cut points.
