Built to look good up closeThe RIGID Series flush mount is a 2-ring round ceiling light: a
brushed nickel finish outer trim framing a
frosted polycarbonate lens, so the fixture reads as a finished piece of hardware rather than a plain disc of plastic. The polycarbonate diffuser hides the LEDs completely and softens the output, which matters a lot on a flush mount because the fixture sits right in your line of sight. At 12" in diameter and only 2.87" tall, it keeps ceilings visually clean in rooms where a pendant or a deep drum shade would feel heavy.
Light quality and the two selectorsColour rendering is the quiet hero here: with a
CRI greater than 90, skin tones, wood floors, paint swatches and merchandise all look like themselves. The
120° beam spread gives broad, even coverage from a single point, which is what you want in a corridor or a small room. The
multiple wattage selector steps through 22W, 18W and 15W, producing 1540, 1260 and 1000 initial delivered lumens, and the
multiple kelvin selector offers five colour temperatures: 2700K, 3000K, 3500K, 4000K and 5000K. Warm 2700K or 3000K for bedrooms and living areas, neutral 3500K or 4000K for kitchens and offices, crisp 5000K for garages, laundry and utility spaces.
Technical specificationsModel: RGD-FM2/12/MW/MK/D/2R
Ordering code: 3662188
Wattage: 22-18-15W selectable
Initial delivered lumens: 1540-1260-1000
CCT: 5 selectable — 2700K, 3000K, 3500K, 4000K, 5000K
CRI: 90
Input voltage: 120V
Dimming: Triac, 10% minimum
Beam spread: 120°
Diameter: 12"
Height: 2.87"
Rated life: L70 @ 50,000 hours
Location: Damp location rated, non-IC rated
Operating temperature: -20˚C ~ +40˚C
Certifications: cETLus rated, T24 qualified
Warranty: 5-year limited
Case quantity: 6
Wiring, dimming and installation notesThis is a standard 120V surface installation: connect to the ceiling junction box, set the wattage and kelvin selectors before you close the fixture, and mount. For dimming, use a
TRIAC (forward phase) dimmer; the fixture dims to a 10% minimum, so plan your dimmer load accordingly and keep the same colour temperature setting across fixtures on the same circuit for a consistent look. It is
damp location rated, which covers covered porches, bathrooms outside the direct spray zone and laundry rooms, and it is
non-IC rated, so it must not be in direct contact with insulation. The -20˚C to +40˚C operating range suits unheated Canadian entryways and garages.
Where it earns its keep, and what pairs with itThink condo corridors on a repeating grid, a basement reno where the ceiling height is already tight, a dental clinic hallway, a boutique fitting-room area, or a four-plex where every unit gets the same fixture. The same family gives you two larger sizes for bigger rooms — the
Rigid Flush Mount II 14" and the
Rigid Flush Mount II 16" — and for a matching bathroom, the brushed nickel
round 2' bathroom light fixture shares the same finish and 5 selectable colour temperatures. The full
technical spec sheet (PDF) for RGD-FM2/12/MW/MK/D/2R is in the Documentation tab, with the dimensional drawing and the complete ordering guide for the 12", 14" and 16" versions.
